HT-SN300 and HT-SN500 Garlic Grinding Machine(vegetables) is made food grade stainless steel material, use high speed rotary tool, different varieties of vegetables, fruits cut up into mud and slurry, meet the needs of food, vegetable and fruit processing. Manufacture this machine suitable for vegetables, fruit juice, vegetable juice extraction, jam, chili sauce and other food in the processing.
Using method: First put the equipment in workshop is flat on the ground, held steady corners. As shown in the above table, the connected power supply. Attention must meet good grounding line. Check material barrel in presence of foreign bodies. Open the power switch, watching the running direction is correct. After normal operation of the equipment will be cleaning and disinfection of the early good fruits and vegetables into a material barrel. In accordance with the requirements for machining installed discharging mouth filter, no filter panel products, adjust good discharge panel. General should be based on user after cutting in different varieties of fruits and vegetables, cutting the thickness difference, moderately improve discharging baffle. The discharging mouth should have a certain gap, continuously feeding and discharging. If cutting the fruit and vegetable varieties are high hardness, more fruits and vegetables, fiber should be pressed the discharging mouth, after waiting for processing to the required thickness to mention keep-off board, so repeated. Note do not use hard objects such as metal and stone into a VAT, otherwise there will be a risk and damage to equipment. After each job should disconnect the power supply first, then will be completely clean equipment, make the material barrel inside do not have material, otherwise you will mildew. Note:Work and cleaning process, should avoid the water splashed into the electric switch, so as to avoid an accident. Maintenance: This equipment used for a period of time, the blade will become dull, impact on cutting the effect will be, at this time should be timely downtime, power off, remove the blade grinding, make it become sharp. Blade removal methods: within VAT blade shaft with a fixed bolt at the top of the discharge should be open, gasket between the blade and the blade and the blade will easily removed, after being good blade grinding, according to the same can be installed. Equipment should be regularly maintenance fixed bolt looseness and the triangle firmness, keep the equipment normal state. Use a period of time, check the equipment inside the bearings are in good condition. If you have questions, it should be replaced in a timely manner.
Packing & Delivery
If you need further information, please contact us freely, we will do our best to cooperate with you.